WORM SCREW GEAR MOTOR WITH PLANETARY GEAR UNIT
EN: Wormed geared motors plus final planetary reduction stage. DC motors till 37 W. Centre distance 20 mm.
USA: Wormed geared motors plus final planetary reduction stage. DC motors till 1/20 HP. Centre distance 0.787 in
MOTOR: continuous current with permanent magnets, totally enclosed. Winding Class F. Power 12 or 24 Vdc. Absorbed power 60 W. Protection IP65 in compliance with IEC/EN 60529 standards.
GEAR UNIT: with worm screw with die-cast aluminium gearcase in the first gear stage and planetary steel gearcase in the second stage . 20 mm centre distance. CARO bronze crown with a hardness of 120÷160 HB. The worm is made of tempered steel, with ground thread. Seal rings in special high-temperature rubber (FKM). Lubrication with special long-lasting oil. There are 6 available gear ratios (i), from 50 to 400. Rated torque up to 15 Nm.
N.B. To choose the right gear motor, please refer to the relevant charts for duty and maximum shaft load coefficients.
These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data.
(*) required information