3d-cubeaccordion-arrowarrow-downarrow-rightattachmentdevicedownloademailfaxfood-beveragehexagonindustriallayerslinklocationminimotor-logo-covernetworkpackagingpagenav-gridpagenav-nextpagenav-prevphoneshare-facebookshare-googleplusshare-linkedinshare-twittersharesocial-facebooksocial-instagramsocial-linkedinsocial-twittersocial-youtubetoolswork-with-us

WORM SCREW GEAR MOTOR

BC2000 12-24MP

12/24 MP WORM SCREW GEAR MOTOR

Technical specifications request information
  • Description

    EN: Wormed  geared motors.  DC motors till 37 W.  Centre distance 20 mm

    USA: Wormed  geared motors. DC motors till 1/20 HP.  Centre distance 0.787 in

  • Characteristics

    MOTOR: Continuous current with permanent magnets, totally enclosed. Winding Class F. Power 12 or 24 Vdc. Absorbed power 60 W. Protection IP65 in compliance with IEC/EN 60529 standards.

    GEAR UNIT: With worm screw and die-cast aluminium gearcase. 20 mm centre distance. CARO bronze crown with a hardness of 120÷160 HB. The worm is made of tempered steel, with ground thread. Seal rings in special high-temperature rubber (FKM). Lubrication with special long-lasting oil. There are 6 available gear ratios (i), from 10 to 80. Rated torque up to 5.2 Nm.   

    Versions B3-B14.

     

    N.B. To choose the right gear motor, please refer to the relevant charts for duty and maximum shaft load coefficients.

    These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data. 

  • Download
  • Configurator

request information

(*) required information

È necessario dare il consenso al trattamento dei dati personali