Stainless steel worm screw gear motor

Technical specifications request information
  • Characteristics

    EN: Stainless steel worm gear motor with AMSS series servomotor. Torques up to 70Nm. 50 mm wheelbase.

    USA: Stainless steel worm gear motor with AMSS series servomotor. Torques up to 620 in-lbs. 1.968 in. wheelbase

    MOTOR: Brushless three-phase 4-pole motor, totally enclosed. Rotor with NdFeB magnets. Thermal cutoff. Winding Class H. Protection IP69K in compliance with IEC/EN 60529 standards. 2-Pole resolver feedback. Bearings with reduced backlash with special grease and high-temperature rubber seal rings. Easy and quick to clean thanks to the smooth surface design. Power 345 to 740 W.

    GEAR UNIT: worm gear unit with stainless steel gearcase. 50 mm centre distance. Bronze crown. The worm is made of tempered steel, with ground thread. Seal rings in special high-temperature rubber. Lubrication with special long-lasting oil for use with foodstuffs (H1). There are 12 available gear ratios (i), from 7 to 100. Rated torque up to 70.0 Nm.


    Version B3 - B14.

    Designed as per EHEDG hygiene guidelines requirements.

    ALWAYS specify application environment.


    These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data. 

  • Configurator

request information

(*) required information

È necessario dare il consenso al trattamento dei dati personali