STAINLESS STEEL WORM SCREW GEAR MOTOR
EN: Stainless steel worm gear motor with AMSS series servomotor. Torques up to 18Nm. 30 mm wheelbase.
USA: Stainless steel worm gear motor with AMSS series servomotor. Torques up to 159 in-lbs. 1.181 in. wheelbase
MOTOR: Brushless three-phase 4-pole motor, totally enclosed. Rotor with NdFeB magnets. Thermal cutoff. Winding Class H. Protection IP69K in compliance with IEC/EN 60529 standards. 2-Pole resolver feedback. Bearings with reduced backlash with special grease and high-temperature rubber seal rings. Easy and quick to clean thanks to the smooth surface design. Power 94 to 180 W.
GEAR UNIT: worm gear unit with stainless steel gearcase. 30 mm centre distance. Bronze crown. The worm is made of tempered steel, with ground thread. Seal rings in special high-temperature rubber. Lubrication with special long-lasting oil for use with foodstuffs (H1). There are 9 available gear ratios (i), from 5 to 80. Rated torque up to 17.8 Nm.
Version B3 - B14.
Designed as per EHEDG hygiene guidelines requirements.
ALWAYS specify application environment.
These gear motors need to be run in. Therefore, for approximately the first 30 operating hours the torque will be lower than what indicated in the data.
(*) required information